BARREL THREADING
This involves the threading of your barrel to allow a silencer to be fitted
Commonly known as screw cutting.
Screw cut to 1/2 inch UMF thread
Cannot be done on barrels smaller than 15mm in diameter
e.g. S400, S410, S310, S300
Barrel on the gun
£55
Barrel off the gun
£40
To screw cut a barrel, you need a centre lathe and have the barrel concentric to the chuck.
The gearing has to be correct on the lathe and the tool post angle has to be set correctly, otherwise you will
quickly ruin your barrel and the cost of a new one could break the bank.
Screw cutting of the barrel is a delicate job involving complex tools, equipment and expertise.
This is not really a job for the shed, let Maverick do it right for you.
